RC multifunction: L-100 ODOMETER

Odometer RC multifuncion L-100 is a precise, lightweight odometer designed for road construction. Odometer is equipped with an easily readable display which concurrently shows all the parameters. Operations through nine buttons are intuitive and fast. 

Odometer RC L-100 measures and displays the following values: roads distance, speed, voltage, and course. Each measurement results in a stored in memory report containing the details of the measurements. The report, after copying it to the computer using a flash drive, can be viewed using a web browser or have it printed.

Odometer has a lightweight plastic case. The case does not provide protection against water.

Tripmeter L 100 with azimuth routing 500

Odometers is designed for cars.

The odometer can be equipped with ultra-fast GPS module supporting up to 66 channels, which in the case of power failure has the ability to recover the GPS signal in less than 1s. The module enables to include in the report the geographical coordinates of each measuring point. It may assist in calculating the road distance or measure it on its own. Due to this manner of functioning the odometer can be connected only to a power source. 

Sample report from Odometer RC: L-100

 Sample report Odometer RC: L-100

The odometer has two independent inputs for connecting conventional speed sensor. To ensure accuracy, the inputs can operate in various configurations:
●    one input with one route counter,
●    one input with one route counter with a backup sensor connected to the second input for a rapid switchover in case of failure,
●    two inputs with two sensors. Odometer performs simultaneous measurements from both sensors mounted on the right and left side of the vehicle, which increases the precision of the measurement.

Odometer has a built-in mechanism for controlling the technical condition of the sensor. In the case of sensor failure or periodic problems with the sensor, the P1 and P2 LEDs indicate the failure to the pilot.

Metrological values under measurement can be measured in three resolution settings, which also changes the promptness of the fast route correction. Indication resolutions are as follows:

●    TRIP - 1m, ODO - 1m, correction ODO +/-1m or any other with the resolution 1m
●    TRIP - 10 m, ODO - 10m, correction ODO +/-10m or any other with the resolution 10m
●    TRIP - 10 m, ODO  - 100m, correction ODO +/-100m or any other with the resolution 100m

Route counting may be in two directions. The odometer can be connected into count back mode (counting backwards).

Odometer can work with two independent external reseters.

Parameters measured by the odometer can be displayed on the optional repeater connected to odometer by bunched cables.

Odometer has convenient mounting holes which make it easy to mount in any vehicle.

Functions :

  • built-in GPS1
  • Two independent road counters with the possibility of deleting
  • the maximum road distance - from 99.99 km to 9999.9 km
  • possibility of correcting the long route - fast correction by a pre-set value or by entering any value
  • two independent sensor inputs working in three configurations
  • system of monitoring the route sensors
  • in case of sensors failure, the possibility of switching over to GPS counting1
  • ultra bright displays and backlit buttons
  • digital protection of settings and measurements memory
  • easily readable GPS signalling of status and range1

1 version with GPS module

  • create reports with the measurements that you can view on your PC or print
  • speed indication
  • route (bearings) indication1
  • Indication of voltage in the vehicle network
  • manual or automatic1 calibration
  • memory of up to 10 calibration coefficients
  • the possibility of changing coefficient during measurement
  • optional external repeater
  • possibility of changing the counting direction (forward/backwards)
  • Possibility of updating firmware by USB flash drive memory


Expendability of odometer functionality

  • The tripmeter functions - The odometer can be additionally equipped with tripmeter’s functions which enable to make auxiliary measurements without having to enter the file name and create reports.