RC multifunction: H-100 AZIMUTH

RC multifunction: H-100 AZIMUTH is a precise, dust and water resistant tripmeter designed for rallies. It is equipped with easily readable LED display which at the same time shows all the measured parameters. With the help of 9 buttons usage is intuitive and fast.

Azimuth RC multifunction H-100 routes waypoints on the basis of distance and the course to the destination and then indicates the direction. H-100 Azimuth displays values indicating the distance and the course to the destination and is intended for off-road rallies.

RC multifunction has a welded steel case that provides rigidity and impact resistance. Double rubber seal provide protection against dust and water. All device's connectors contain a sealed enclosure.

 RC multifunction: H-100  AZIMUTH

The tripmeter is designed for any vehicle.

Tripmeter can be equipped with ultra-fast GPS module supporting up to 66 channels, which in the case of power failure has the ability to recover the GPS signal in less than 1s. The module is used to determine the position during the routing process. Thanks to the fast GPS module, routing waypoints can be done also while driving at any speed.

Navigating to a routed waypoint takes place as indicated by the distance and the course to the destination. These parameters are shown on the display of the device. The screen also displays a clear pointer towards the destination..

Sending and routing a waypoint using the Rally computer multifunction takes just 1 second!!! At each point you can save about 20 seconds.

Additionally, if the RC H-100 is connected via cable to your Garmin device, a waypoint will be sent to the Garmin device and will be shown on its display.

The device has a built-in menu that allows you to create files with azimuths and to edit or delete them. There is also the possibility of uploading, via USB, the files with azimuths prepared on a PC.

Parameters measured by the tripmeter can be displayed on the optional repeater connected to tripmeter by bunched cables.

Tripmeter has eight convenient mounting holes with M4 threads which make it easy to mount it in any vehicle. Additionally, the set includes the angular brackets facilitating installation.

Functions :

  • built-in GPS1
  • Two independent road counters with the possibility of deleting
  • the maximum road distance - from 99.99 km to 9999.9 km
  • possibility of correcting the long route - fast correction by a pre-set value or by entering any value
  • two independent sensor inputs working in three configurations
  • system of monitoring the route sensors
  • in case of sensors failure, the possibility of switching over to GPS counting1
  • ultra bright displays and backlit buttons
  • hermetic, steel case
  • digital protection of settings and measurements memory
  • easily readable GPS signalling of status and range1

1 version with GPS module

  • speed indication
  • route (bearings) indication1
  • Indication of voltage in the vehicle network
  • manual or automatic1 calibration
  • memory of up to 10 calibration coefficients
  • the possibility of changing coefficient during measurement
  • optional external repeater
  • possibility of changing the counting direction (forward/backwards)
  • Possibility of updating firmware by USB flash drive memory

 

There are versions of the tripmeter with cables led out of the back of the casing or connectors located at the bottom of the casing.

 

Functions expandability

AZYMUT - additionally waypoint routing that is connecting functions: TRIPMETER + AZYMUT

User guide