Rally computer multifunction TRIPMETER

Rally computer multifunction TRIPMETER is a precise, dust and water resistant tripmeter designed for rallies. It is equipped with easily readable LED display which at the same time shows all the measured parameters. Tripmeter is operated by a 6-button, backlit keyboard.

Rally computer multifunction TRIPMETER measures and displays the following value: route distance, speed, voltage, direction. It is designed for any type of rally. In conjunction with the ride on regularity function it is designed for historical car rallies.

Rally computer multifunction TRIPMETER

The tripmeter is designed for cars as well as motorcycles and quads.

The tripmeter can be equipped with ultra-fast GPS module supporting up to 48 channels. The module helps in calculating road distance or does it all on its own. With this solution it suffices to connect the tripmeter only to the power source.

The tripmeter can be also connected to any type of speed sensor.

Measured values of distance travelled are shown with a resolution of 10 m. Quick adjustment of ODO route is also carried out at the same resolution.

Road counting may be done in two directions. It is possible to switch over into countback mode (counting backwards).

The tripmeter can cooperate with one external reseter or four button wheel mounted reseter.

The tripmeter has convenient mounting points which make it easy to mount it in any vehicle.

Waypoint routing in Garmin based on azimuth and distance

It is possible to integrate the tripmeter with the functions of Rally computer multifunction AZIMUTH device. All the features of AZIMUTH device are then available in the tripmeter.

The integration enhances the possibilities and speeds up navigation by road book.

Working with repeater

Rally computer multifunction TRIPMETER can work as the main tripmeter for Rally computer 3 + acting as a repeater. In each of the operating modes of the main tripmeter, the leading measure: TRIP STOPER or AZC (course to the destination) is automatically sent to repeater. At any time, any measured parameter can be sent to repeater.

Functions :

  • built-in GPS1
  • Two independent road counters with the possibility of deleting
  • the maximum road distance - from 99.99 km to 9999.9 km
  • possibility to correct a long road - fast correction after +/- 10 m
  • road sensor input
  • in case of sensors failure, the possibility of switching over to GPS counting1
  • ultra bright displays and backlit buttons
  • digital protection of settings and measurements memory
  • easily readable GPS signalling of status and range1

1 version with GPS module

  • speed indication
  • route (bearings) indication1
  • Indication of voltage in the vehicle network
  • manual or automatic1 calibration
  • memory of up to 10 calibration coefficients
  • the possibility of changing coefficient during measurement
  • optional external repeater
  • possibility of changing the counting direction (forward/backwards)
  • Possibility of updating firmware by USB flash drive memory
  • Possibility of extending functions to include waypoint routing based on the azimuth and the distance

 

User guide