Tripmeter Rally computer: 3 +

Tripmeter Rally computer 3 + is a precise, dust and water resistant tripmeter designed for rallies. The tripmeter is equipped with easily readable LED display which shows the parameter. It is operated by 3-button backlit keyboard.

Tripmeter Rally computer 3 + measures and displays the following values: road distance, speed, time, voltage, route direction (bearing). In conjunction with waypoint routing function it is designed for off-road rallies.

Tripmeter Rallycomputer 3 plus 500

The tripmeter is designed for cars as well as motorcycles and quads

The tripmeter can be equipped with ultra-fast GPS module supporting up to 48 channels. The module helps in calculating road distance or does it all on its own. With this solution it suffices to connect the tripmeter only to the power source.

The tripmeter can be also connected to any type of speed sensor.

Measured values of distance travelled are shown with a resolution of 10 m. Quick adjustment of ODO route is also carried out at the same resolution. In Rally computer 3+ the measurements are made in one of the two following modes:

DISTANCE - the main route measuring parameter
STAGE – the main time measuring parameter

Road counting may be done in two directions. It is possible to switch over into countback mode (counting backwards).

The tripmeter can cooperate with one external reseter or four button wheel mounted reseter.

The tripmeter has convenient mounting points which make it easy to mount it in any vehicle.

Functions :

  • built-in GPS1
  • Two independent road counters with the possibility of deleting
  • the maximum road distance - from 99.99 km to 9999.9 km
  • possibility to correct a long road - fast correction after +/- 10 m
  • road sensor input
  • in case of sensors failure, the possibility of switching over to GPS counting1
  • ultra bright displays and backlit buttons
  • digital protection of settings and measurements memory
  • easily readable GPS signalling of status and range1

1 version with GPS module

  • speed indication
  • route (bearings) indication1
  • Indication of voltage in the vehicle network
  • manual or automatic1 calibration
  • memory of up to 10 calibration coefficients
  • the possibility of changing coefficient during measurement
  • optional external repeater
  • possibility of changing the counting direction (forward/backwards)
  • possibility of updating firmware by USB flash drive memory
  • possibility of extending functions to include waypoint routing based on the azimuth and the distance

 

Working in the repeater mode

The Rally computer 3+ tripmeter can work as a repeater; this applies to Multifunction series tripmeters and to RC6+. Each parameter measured by the main tripmeter can be shown on Rally computer 3+ tripmeter functioning as a repeater.

 

Tripmeter Rallycomputer 3 and repeter Rallycomputer 3

User instructions

User guide & How to connect

Video instructions

Click here.