Tripmeter Rally computer 7

Tripmeter Rally computer 7 is a precise, dust and water resistant tripmeter designed for rallies. The tripmeter is equipped with easily readable LED displays where selected parameters are shown in two separate windows. With the help of 14 buttons usage is intuitive and fast. The buttons are permanently assigned to particular functions.

Tripmeter Rally computer 7 measures and displays the following value: route distance, speed, time, voltage, direction/bearings, direction/ bearings to destination as well as distances on azimuth drive. It is designed for any type of rally. In conjunction with the ride on regularity function it is designed for historical car rallies.

Tripmeter Rallycomputer 7 gps 500

The tripmeter is designed for cars as well as motorcycles and quads.

The tripmeter can be equipped with ultra-fast GPS module supporting up to 48 channels. The module helps in calculating road distance or does it all on its own. With this solution it suffices to connect the tripmeter only to the power source.

The tripmeter can be also connected to any type of speed sensor.

Measured values of distance travelled are shown with a resolution of 10 m. Quick adjustment of ODO route is also carried out at the same resolution.

Road counting may be done in two directions. It is possible to switch over into countback mode (counting backwards).

The tripmeter can cooperate with one external reseter or four button wheel mounted reseter.

The tripmeter has convenient mounting points which make it easy to mount it in any vehicle.

Regularity mode

The tripmeter with an active function for regularity rally it is a successful combination of an electronic speed chart and a tripmeter. It allows you to enter before the start of the regularity section, the set by the organizer average speed, and then shows information on gains or losses in relation to the perfect drive. Gain or loss are shown as road parameter with the resolution of 10 m.

Currently, before the start of the section, you can enter into the tripmeter up to ten ideal average speeds, and, during drives for regularity, instantly change them. You can also start with one ideal average speed entered into your tripmeter memory, and during the section enter a new ideal average speed and make the change.

Tripmeters equipped with an additional connector can be equipped with two-colour LED that in a simple way inform you whether you are going too slowly or too fast in relation to the ideal average speed specified by the organizer.

The tripmeter offers also the possibility of a prompt correction of the route driven for regularity, so as to adjust it to the actually travelled distance. This allows for the correction of errors resulting from e.g. the shape of the driven route, etc.

The tripmeter complies with international regulations, that is does not indicate the average speed.

Working with repeater

Tripmeter Rally computer 7 can work as the main tripmeter for Rally computer 3 acting as a repeater. In each of the operating modes of the main tripmeter, the leading measure: TRIP STOPER or AZC (course to the destination) is automatically sent to repeater. At any time, any measured parameter can be sent to repeater.

 Tripmeter Rally computer 7 gps azimuth and repeter Rally computer 3

Functions :

  • built-in GPS1
  • Two independent road counters with the possibility of deleting
  • the maximum road distance - from 99.99 km to 9999.9 km
  • possibility to correct a long road - fast correction after +/- 10 m
  • road sensor input
  • in case of sensors failure, the possibility of switching over to GPS counting1
  • ultra bright displays and backlit buttons
  • digital protection of settings and measurements memory
  • easily readable GPS signalling of status and range1

1 version with GPS module

  • speed indication
  • route (bearings) indication1
  • Indication of voltage in the vehicle network
  • manual or automatic1 calibration
  • memory of up to 10 calibration coefficients
  • the possibility of changing coefficient during measurement
  • optional external repeater
  • possibility of changing the counting direction (forward/backwards)

 

User guide

Video instruction